Lower limb support OKD-03/20
LOWER LIMB IN 20° FLEXION IMMOBILIZER
Product description
The product is available while stocks last
Lower limb extension immobilizer OKD-03 is made of ActiveDistance II, which is non-allergic for patient’s skin. This material is soft, non-elastic, easy to attach on the external side and with cotton internal surface.
The brace is equipped with:
- Open and soft sleeve which enables to adjust the device to the diverse measurements of bottom limb.
- System of VELCRO stickers which assure proper adhesion the device to the body and more effective stabilization of limb.
- System of anatomically profiled aluminium splints with independent fixing system to product’s sleeve.
- The kneecap protection with fastener adjustment.
Such construction of article makes possible to adjust the device individually, easily and precisely to the patient’s body as well as assures sure stabilization of limb.
Purpose of use
Lower limb extension immobilizer should be applied in cases of:
- knee dislocation,
- knee twist and sprain,
- side instability of the knee joint,
- knee ligaments LCL, MCL and ACL injuries,
- knee ligaments reconstruction,
- other surgeries (orthopedic).
Available sizes
| Size | (A) Thigh circumference 15 cm above the center of the patella | (B) Calf circumference 15 cm below the center of the patella | (C) Product length | How to measure |
| Single size | 40-65 cm (15,7″-25,6″) |
30-50 cm (11,8″-19,7″) |
55 cm (21,7″) |
 |
Total length of product: 54 cm (21,3″)
Setting up
Orthopedic splint strips
Orthopedic splint strips – a set of four (two rear and two lateral) anatomically shaped orthopedic splints. They are made of high quality duralumin characterized by high mechanical endurance (over 400MPa). Therefore they are perfectly suitable for immobilization of lower limbs after the knee arthroscopy. Braces with front knee cap are used in upright standing and rehabilitation of patients with paresis.
Optional equipment
Under knee pillow
Downloads
Medical products class 1 – conforming the directive of the Board (93/42/EEC) concerning medical products. Producer of orthopedic and medical products, firm REH4MAT issued appropriate EC declaration of conformity.
